INSCMagazine: Get Social!

When you’ve invested energy and money in your home, you want to make sure it stays in good condition for as long as possible. This is why one of the most disheartening things that can happen is to get a stain or burn on your carpet. However, just because your carpet has been in an accident doesn’t mean you need to replace it. You can repair carpet Sydney.

Repair Surface Stains or Burns

Repairing a burn or minor stain can be as simple as trimming the ends of damaged carpet fibres. Using a pair of scissors or even a nail, thoroughly clean the stained ends. Don’t cut too much or too deep into the mat or it will look like you have a bad haircut.

If the mark is deeper, you may need to borrow carpet fibres. Remove damaged fibres to the bottom of the carpet, then cut replacement carpet fibres from an offline area, such as the back of a closet.

Resurrect the Crushed Carpet

If your carpet has just been crushed under the weight of the furniture, you can probably find it with a bottle of water and a hairdryer. Just moisten the crushed fibres, and drying them with the hairdryer, brush them with your hand.

Replace a Damaged Section

If you have a stain that is deep in the fibres or covers a larger area, you will need to replace the damaged section. Hope you still have some carpet scraps that you saved on the initial installation.

Remember that all rugs have grain or texture due to their workmanship. Brush it in such a way that the fibres rise. Experts suggest replacement parts are less noticeable if cut in the shape of a triangle or a circle. In a way, squares and rectangles attract attention.

Cut Your Spare Part

When it comes to cutting out the stained section, you have a few choices. You can use the lid of a box as a template. Nail the cover to the floor and using a sharp tool knife, trim the edges of the cover. Use the same cover to cut your replacement part, and you will have a very close resemblance.

A more precise method is to lay your spare directly on the stained area, then cut both layers of carpet at the same time. This way your replacement part exactly matches the shape of the damaged section you are removing.

Attach the Spare Part

The double-sided carpet is the easiest method of setting up the room. First, place the tape on the floor, make sure it goes towards the edge of the hole, then peel the top of the tape and place the piece in the hole. The carpet tape will hold the piece, but over time it will dry out and lose its adhesion. In addition, it will not withstand the humidity of cleaning your rugs.

Another method of attaching your piece is to use clear waterproof adhesive or clear silicone caulk. Either of these will hold up better over time and will not be damaged by carpet cleaning service fluids. Place the adhesive around the edges of the piece and press it into the hole.

Brush the fibres of the patched-up piece and the intact carpet with your hand to remove the visible line where the piece meets the carpet. Put weight on the part and leave it on for 24 hours.

Additional Information

When you cut out the damaged piece of carpet, keep the underlay that appears. You will need to put it back in the hole to make sure the height of the room is the same as the original rug. If the underlay itself has been damaged, you can use a piece of material like a backpack as a substitute.

Here are some tips to help you do a little DIY on your damaged rugs. Even if the result is not the same as the original condition, it will still be much better than a large stain or a burn.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.