Renovating your old house always includes essential tasks like electrical system upgradation. Sometimes it may end up on damaging your home if not done properly. But you don’t have to worry at all! As we are here with an experts’ guide on Rewiring a House to provide you with all major and minor details. Scroll down to know it all.
Nowadays computers, TVs, air conditioners, or refrigerators all are undetachable part of our daily life. If all these facilities were not installed when your house was first wired, then rewiring is very important to avoid any electrical mishap while using several devices and gadgets. We are rendering the fool scoop here regarding how to rewire a house. Have a look now.
Rewiring A House – The Safety Tips!
Being an empowered homeowner is fascinating itself, and for that, you need to know the whole electrical system of your house. So, if you are planning to rewire your home here is some pro-tips for you,
Firstly, Create a Diagram
To begin with the rewiring task, you need to make a wiring diagram first. The diagram must show the location of the breaker box along with the path of the wires covering all the outlets.
Install the Channel
After having the diagram in your hand, now it’s time to start the actual rewiring work. Run the longest wires to avoid wastage conduits inside your wall. Place the wire from upstairs and then pull it down through the basement. Make sure you kept at least one foot of extra wire at the end.
Make an Outlet Count
You will have to count the number of outlets and switches will run on a single circuit. For the living area, six outlets each with 110 volts is advisable. Whereas for the kitchen, two per circuit is the standard. Since the kitchen outlet will be used for appliances like mixer grinder, blender, micro oven it requires more wattage.
Drill Wire Holes
Before you drill any holes on the wall or floor, thoroughly check the other side. Otherwise, there are possibilities of drilling through water pipes, ductwork or electrical wires. Drill holes with a 1-inch bit at the center of the studs through which the cables will pass. The increase in the number of outlets improves the safety of your home.
Set a Breaker
Setting the breaker box at the right location of your house is an important task. For the breaker box, you must choose a place where you have better access. A place in the basement area can be the ideal choice. If you have a utility room, you can consider putting the breaker box there as well.
Pull the wires to the outlets
Once you decide the breaker box position, keep the wire roll beside the breaker box and then pull the cord according to the diagram you have. If you want you can run the wires through the table too.
To remove the outer coating from the ends of the wire use wire strippers. Follow the instructions written on the box, outlets, and switches to ensure the proper connection.
Finally, Install the circuits
Each wiring requires individual circuits. Therefore you will have to install separate circuits for each wiring sets. But before that, you will have to ensure that each circuit matches the amperage of the wire.
Wrap Up
Though this DIY can help you in rewiring a house, it will be better to take help from the professional to get the job done. Ultimately proper shock proof wiring is one of the key things of a safer house.